Pro-face LM4201TADDK PFXLM4201TADDK Touch Panel Film

Order each part separately is available

LM4201TADDK PFXLM4201TADDK Maintenance
 NEVER touch a live power terminal. Doing so could cause an electrical shock or a machine malfunction.
 To prevent an electrical shock, unplug the LM4201TADDK PFXLM4201TADDK HMI Panel Glass Protective Film LT unit's power cord before either cleaning the LT or attaching/detaching the power terminal attachment screws.
 Do not connect or disconnect Host and LT unit communication cables while the LT is turned ON.
 Do not replace the LM4201TADDK PFXLM4201TADDK Front Overlay Touch Screen Monitor LT unit's battery yourself. The LT uses a lithium battery for backing up its internal clock data and the battery may explode if it is replaced incorrectly. When replacement is required, please contact your local LT distributor.

Be aware of the following items when building the LT into an end-use product:
• The LT unit's rear face is not approved as an enclosure. When building the LT unit into an end-use product, be sure to use an enclosure that satisfies standards as the end-use product's overall enclosure.
• The LM4201TADDK PFXLM4201TADDK Touch Screen Panel Glass Front Overlay LT unit must be used indoors only.
• Install and operate the LM4201TADDK PFXLM4201TADDK Protective Film Touch Panel LT with its front panel facing outwards.
• If the LT is mounted so as to cool itself naturally, be sure to install it in a vertical panel. Also, it's recommended that the LT should be mounted at least 100 mm away from any other adjacent structures or machine parts. The temperature must be checked on the final product in which the LT is installed.
• For use on a flat surface of a Type 4X (Indoor Use Only) and/or Type 13 Enclosure.